RC-Dude
Very Active Member
- Messages
- 1,591
- Reaction score
- 3,327
Why does a bullet connector become unsoldered?
Was flying with a 70mm EDF jet. Motor pulls 92 Amps on 6s. Motor starts sputtering while flying. Manage to land. Melted soldering lead 60/40 outside of one bullet. Remove the tubing and the bullet falls out. The other two bullets are still soldered rock solid.
Bad soldering connection and Amps too high for a poor connection?
Was flying with a 70mm EDF jet. Motor pulls 92 Amps on 6s. Motor starts sputtering while flying. Manage to land. Melted soldering lead 60/40 outside of one bullet. Remove the tubing and the bullet falls out. The other two bullets are still soldered rock solid.
Bad soldering connection and Amps too high for a poor connection?
Last edited: