Big Rock Added 3D printed lights to my Big Rock

[sideshowgaz]

I masked off the lights area when I painted the body. I then printed the LED holders and filled them with hot glue and stuck them to the inside of the body so there are no holes in it. Then everything got a liberal amount of glue and drywall tape

 

[ShagNasty68]

I masked off the lights area when I painted the body. I then printed the LED holders and filled them with hot glue and stuck them to the inside of the body so there are no holes in it. Then everything got a liberal amount of glue and drywall tape

Did a great job you got some skills for sure.

 

[sideshowgaz]

Did a great job you got some skills for sure.

Thank you sir. Very kind of you to say

 

[Esk8erfpvrc]

Great job on these. It's funny cause i had downloaded this from thingiverse and i noticed the link to here. My Big Rock gets in tomorrow. Thanks for sharing.