Can't disassemble brushless motor

[Prisma]

Hey everyone,

I wanted to make sure my brushless motor is clean inside so I don't destroy it, and the screws holding it together are super tight. Whatever I do I can't get them to budge. Any advice on removing those? I've never disassembled this motor before.

Thanks for any replies

 

[Engineer]

Use a good driver (MIP, etc.) and apply some heat to the screws as there may be thread locker on them.

 

[Prisma]

Use a good driver (MIP, etc.) and apply some heat to the screws as there may be thread locker on them.

Alright thank you! Gonna try some heat.

 

[GraniteFox]

Soldering iron on the screw then back it out with a good driver.....go slow.