DoubLRRLIFE!8887
Very Active Member
- Thread starter
- #21
Contact spray l? Link please thank youThe anti-spark arrestor Resistor(s), always on the Neg side, do fail at some point, Yes.
I experimented with using a Silicone specific Dielectric Grease. Don't do it! Be warned. Not for High Volt High Amped connectors. I use dielectric grease only on very low volt, low amp load connections. And very Sparingly. Serves a purpose, just not good for Lipo pack connectors. Also don't use Dielectric grease on a Sensor lead/ pinouts. Messes with the Low freq. sensor signals. Causes the the connector to foul up.. Attracts dirt, grit. This can even wear out the barrels/ bullets. Again, been there. I even saw arcing with this grease.
Just keep the connectors clean and dry, with Elect. Contact spray.