Granite Granite BLX 3S Stripped Pinion and Spur Gear

[Camaroboy383]

After much drama ... I have sealed motor bearings installed!
Wasn't easy. I actually needed your heat tip to get the bearing IN. It wouldn't fully seat. Heated it up a bit and it finally popped in.

Glad you got it sorted buddy.. another trick for future endeavors is put the bearing in the freezer for a little while..(15-20 mins).. heat the housing some and the cold bearing will fall right in.. ?

 

[GRC]

Glad you got it sorted buddy.. another trick for future endeavors is put the bearing in the freezer for a little while..(15-20 mins).. heat the housing some and the cold bearing will fall right in.. ?

Nice, I still have the new motor that was replaced under warranty to install bearings in, so I'll do that.