beefy nugz
Active Member
- Messages
- 240
- Reaction score
- 109
- Arrma RC's
Just replaced front diff case and ended up doing a bearing job and checked all diffs. All back together but I can’t figure out what this rough clicking noise is. When you free roll the vehicle you it’ll go from smooth to rough in the same spot of the rotation. I’ve narrowed it down to the rear diff. All gears in diff including including input gear all look perfect inside the rear diff.
Basically when rear diff cover is off I can spin the input drive gear all the way around and its very smooth as it turns the dig bones. As soon as I tighten down the lid to the rear diff the roughness comes back. Pull the lid off and its smooth again!!! It’s almost like putting pressure on the bearings attached to the rear diff causes rough noisy gears.
anybody have any advise?
been working on this for a few days now and it’s getting quit frustrating.
Thanks!!!!
Basically when rear diff cover is off I can spin the input drive gear all the way around and its very smooth as it turns the dig bones. As soon as I tighten down the lid to the rear diff the roughness comes back. Pull the lid off and its smooth again!!! It’s almost like putting pressure on the bearings attached to the rear diff causes rough noisy gears.
anybody have any advise?
been working on this for a few days now and it’s getting quit frustrating.
Thanks!!!!