Edough13
Bashing, Speed running and family!!
Premium Member
Excellence Award
Hospitality Award
Build Thread Contributor
- Messages
- 10,269
- Reaction score
- 13,274
- Location
- Northern California, USA
- Arrma RC's
- BigRock 4x4
- Granite
- Limitless
- Kraton 6s
- Mojave
- Notorious
- Typhon 6s
- Vorteks
Nice sounds like everything is doing great so far The spur will be more effected by the gear mesh, slipper adjustment, debris in the housing and motor bearings not so much the diff gears. Now if you put like 500k in them lol and basically locked the diffs then yes but also slipper would help take the stress, otherwise diffs shouldn't effect the spur at all.@BulletRCs_NZ @Edough13
Thx post sharing about your metal diff. I still have more runs and testing to do but had a chance this evening to get 2 full 3S 6200mah runs. You know when you get something new try to feel it out and not get caught on the high of having something new.
I ran it in my same spot on loose dirt and in past I did not get the dragster takeoff wheelie (not a full walking wheelie) so it was nice to see the front end lift a little. Hate wheelies in general but the gearing felt really good in the rear. It had rained 24hrs prior so the dirt was not dusty or extremely loose but was not wet either, so I need to see what it will do when it is bone dry.
I look forward to more bashing to keep testing. My hope since I have strengthened the rear diff that this does not transfer that energy to my plastic spur as the next weak point. I'm hoping the M2C motor plate adds stability to that area for the spur.
Thx fellas