So I'm setting up my new build. Shock collars for the front and rear were set at the same height (Same on rear, same on front, not the same all around). Set the initial height by using calipers to measure, measuring at the front and rear corners of the scorched chassis. Now here's where I need some advice. Once that's set I used the Raz method of lifting underneath the front and rear separately in the middle using a hex driver to make sure the tires came off the ground at the same time. They didn't so I adjusted as needed until they did. Now when the car is sitting it visibly leans to one side. I went back and forth around the car for the last couple hours and no matter what I do I can't get it level as well as get each pair of tires to come off the ground at the same time. Thanks!!
Edit: Since this is a speed run car only it has no sway bars. Figured I'd add that if it makes a difference.
Edit: Since this is a speed run car only it has no sway bars. Figured I'd add that if it makes a difference.