Gorgon NEW GPM 7075 Servo Saver
- Thread starter BigP
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
332_RC
Very Active Member
- Messages
- 1,886
- Reaction score
- 5,011
- Location
- USA, Georgia
- Arrma RC's
- Gorgon
- Infraction
- Kraton 6s
- Notorious
- Senton 3s
- Infraction 4x4
Actually yes, I put that exact GPM one in my brushless Gorgon. I thought the stock saver had broken, so I got that GPM one. The saver was in fact nearly broken, but my problem was the servo itself. I took it all out, & I could spin the servo all the way around, not much resistance. It had stripped, but not fully. So you might consider replacing both. The GPM saver is great though. Well machined & fit right.
332_RC
Very Active Member
- Messages
- 1,886
- Reaction score
- 5,011
- Location
- USA, Georgia
- Arrma RC's
- Gorgon
- Infraction
- Kraton 6s
- Notorious
- Senton 3s
- Infraction 4x4
Here's some pics. Hope this helps.
I went with a Power HD 23kg servo. I had to file about 0.020" off the hat of the servo to get it in the chassis. Equal amounts each side. It's a tight fit in the chassis where it mounts into, but it fits secure & snug. No movement.
I went with a Power HD 23kg servo. I had to file about 0.020" off the hat of the servo to get it in the chassis. Equal amounts each side. It's a tight fit in the chassis where it mounts into, but it fits secure & snug. No movement.
Last edited:
