needbout350
Fairly New Member
- Messages
- 27
- Reaction score
- 19
Just got my son a new granite 3s v2 this weekend. Been running it on 2s and 3s at 50% throttle and it is cogging a ton at start up. Some times it won’t even go until we give it a push. Once it’s moving there are no issues until we come to a stop again.
I tried it at 100% on 2s and 3s still the same issue. The truck is 100% stock.
I checked the mesh and felt it was a little tighter than I liked but not tight enough to cause these problems. I adjusted it a bit and still the issue persisted.
My guess is the esc is junk. Is this a common problem with the blx100 esc or do I have a fluke failure that arrma should replace?
I also have a spare hobbywing 10bl120 I was considering mounting up but I wasn’t sure how it would like the 4 pole sensorless motor.
What do you guys think I should do?
I tried it at 100% on 2s and 3s still the same issue. The truck is 100% stock.
I checked the mesh and felt it was a little tighter than I liked but not tight enough to cause these problems. I adjusted it a bit and still the issue persisted.
My guess is the esc is junk. Is this a common problem with the blx100 esc or do I have a fluke failure that arrma should replace?
I also have a spare hobbywing 10bl120 I was considering mounting up but I wasn’t sure how it would like the 4 pole sensorless motor.
What do you guys think I should do?