Senton Senton 3s BLX cutting out

[332_RC]

My Senton 3s BLX keeps cutting out. It may be the battery. But do these Arrma ESC's have problems cutting out? It goes a little bit then starts chugging. I turn ESC off then on again & it works but starts chugging again. When I charge the battery the charger stops before its fully charged & states 'OVERCHARGED' Any ideas?

 

[Senton_Prime]

My Senton 3s BLX keeps cutting out. It may be the battery. But do these Arrma ESC's have problems cutting out? It goes a little bit then starts chugging. I turn ESC off then on again & it works but starts chugging again. When I charge the battery the charger stops before its fully charged & states 'OVERCHARGED' Any ideas?

What battery and charger you using?

 

[332_RC]

What battery and charger you using?

Passport Ultra P2 & a ZEEE 5200mah, 80c

 

[SrC]

.
What ESC Led flashing code sequence and color are you getting when it cuts off?

Red flashing = LVC cutting ( battery voltage issue)
Green flashing=Thermal cutting (ESC is too hot)
And there are other flash sequence codes...

 

[Senton_Prime]

Passport Ultra P2 & a ZEEE 5200mah, 80c

Have you went through all your settings and made sure the parameters are all correctly set for that lipo, also have you read the manual!?

 

[332_RC]

.
What Led flashing code sequence and color are you getting when it cuts off?

It's the stock Arrma 85a ESC. Ya know I didn't pay attention. My bad. Last time I ran the same battery on my Infraction 3s BLX it did fine & it was like 97° that day on asphalt. It was hot the day the Senton started doing too. What lights should I look for? It might be a few days tho. I busted a axle on the Senton & haven't fixed it yet.

Have you went through all your settings and made sure the parameters are all correctly set for that lipo, also have you read the manual!?

I did read the manual but it's been a min. I left everything as stock set. I will read again.

.
What ESC Led flashing code sequence and color are you getting when it cuts off?

Red flashing = LVC cutting ( battery voltage issue)
Green flashing=Thermal cutting (ESC is too hot)
And there are other flash sequence codes...

Thank you. I will definitely pay attention next time I run it.