I wanted onboard video from my Mojave EXB and wanted the GoPro inside of the passenger compartment due to it being better protected and I like the view the camera gets inside the roll cage. Due to the arms of the "driver" and "navigator" there wasn't a flat enough surface to mount the camera so I drew and 3D printed one that fits around the arms. As you can see in the video it is aimed a little low so Ver 2 sits a little higher, it is printed however I haven't had a chance to install and test yet. Just for testing I am using zip ties however once I am happy with the mount it will use straps from my quad copter batteries. For now the camera sits in a TPU GoPro Sessions shell for drone racing but I will be making one that will fit better in the Passenger compartment. Once i am happy with everything I will be upload to Thingiverse and post a link if any one would one.