- Messages
- 743
- Reaction score
- 1,553
- Arrma RC's
- Notorious
Ok so have the build done (pics coming later today), and I function tested it yesterday (bashed it?). After which I was excited to use my new m2c motor mount with the easy access center diff, which was awesome before I got the GKA braces, only to realize that you can't get the diff out because A) The tolerances are really tight everywhere on my truck, which causes B) The rear center driveshaft can't clear the brace without undoing the chassis bolt for the brace and sliding it over. ?
I bought the m2c mount for those two features, I bought the GKA braces cause they're bulletproof in build quality. So, does anybody else have this combo? Have you modded your brace to get the rear driveshaft to clear? I don't wanna kick off on it with a dremel just yet to find a solution. Was thinking of tapping the brace to fit a larger bolt, that way I don't have to hold one side with a driver while removing the other. It was soooooo close to clearing, if I did dremel it, it would just be to smooth out the angle of cutout on the top side.
I bought the m2c mount for those two features, I bought the GKA braces cause they're bulletproof in build quality. So, does anybody else have this combo? Have you modded your brace to get the rear driveshaft to clear? I don't wanna kick off on it with a dremel just yet to find a solution. Was thinking of tapping the brace to fit a larger bolt, that way I don't have to hold one side with a driver while removing the other. It was soooooo close to clearing, if I did dremel it, it would just be to smooth out the angle of cutout on the top side.