I recently purchased an Infraction with a TP 4070 2200kv motor and a Mamba Monster 2 ESC. Gearing is MOD 1 24T pinion 46T spur and I ran 1 pack through it today and the motor was so hot I could not touch it and it stunk, and the motor wires were pretty damn hot too. The ESC was not hot, barley warm. When I bought it I had to re-solder everything I used 8mm bullets. I am running 6500Mah 60c 6s batteries with an EC5 connector and killmode cap pack. I do not have a heat sink or fan setup on the motor yet but it was like 50deg out today and my motor got so hot it may have gotten fried. Can anyone give me any insight or advise on if my greaing is ok and what else could be causing the motor to overheat? Thank you.
Last edited: