Kevin_McCubbin
Active Member
- Messages
- 97
- Reaction score
- 43
- Location
- Chicago Suburbs
- Arrma RC's
- Infraction
- Kraton EXB
- Typhon 6s
- Typhon TLR
I am running a Castle MMX8S and. Castle 1717-1650 in my Infraction. I want to put a new cap pack on it.
I bought the power hobby 12S cap pack and I want to wire it up on bullet connectors instead of soldering it to the esc wires because I can never make it clean. However my question is how exactly? I think if there was a 6.5mm Y connector that would be ideal but I can’t find anything like that. How has everyone else wired it up to make it look clean and not cluttered but also for good function? I just think that soldering to the wires going into the esc wires presents an issue as far as shrink wrapping them and potentially with getting the most out of the cap pack. I also have a Castle 12s cap pack but it is half as large as the power hobby one so I can only imagine it cannot story nearly as much power. Does anyone have any suggestions?
I bought the power hobby 12S cap pack and I want to wire it up on bullet connectors instead of soldering it to the esc wires because I can never make it clean. However my question is how exactly? I think if there was a 6.5mm Y connector that would be ideal but I can’t find anything like that. How has everyone else wired it up to make it look clean and not cluttered but also for good function? I just think that soldering to the wires going into the esc wires presents an issue as far as shrink wrapping them and potentially with getting the most out of the cap pack. I also have a Castle 12s cap pack but it is half as large as the power hobby one so I can only imagine it cannot story nearly as much power. Does anyone have any suggestions?
Last edited: