- Messages
- 1,802
- Reaction score
- 3,286
- Location
- Tennessee
- Arrma RC's
- Felony
- Infraction
- Limitless
- Kraton EXB
- Mojave
- Outcast EXB
- Senton 6s
- Vendetta
So I grabbed one of these a week or two ago. Have only really played with it. But after using it for a major repair I think it's worth reviewing and im glad its in my tool box now.
This is the one that I purchased:
https://www.amazon.com/dp/B081C946ZJ?psc=1&ref=ppx_yo2ov_dt_b_product_details
If you have a 3D pen share you experiences and tips/tricks you have done with it.
I had a failed print and had to cut and print a portion to make it whole. Needless to say it didnt work out very well. Again im no genius here, shoot from the hip as usual till I get my own process .
Look at these gaps!!! The roof wasnt bad so its what I lined up very small gap, the sides however well... Take a look!!
3D Pen and some sanding and its lookin nice. Surprisingly strong to.
Filled it in on the inside and outside:
Dremel for about 15 minutes then sanding for about 10 minutes. Not to shabby. Little primer filler will fix it all right up.
This is the one that I purchased:
https://www.amazon.com/dp/B081C946ZJ?psc=1&ref=ppx_yo2ov_dt_b_product_details
If you have a 3D pen share you experiences and tips/tricks you have done with it.
I had a failed print and had to cut and print a portion to make it whole. Needless to say it didnt work out very well. Again im no genius here, shoot from the hip as usual till I get my own process .
Look at these gaps!!! The roof wasnt bad so its what I lined up very small gap, the sides however well... Take a look!!
3D Pen and some sanding and its lookin nice. Surprisingly strong to.
Filled it in on the inside and outside:
Dremel for about 15 minutes then sanding for about 10 minutes. Not to shabby. Little primer filler will fix it all right up.