3s control arm lengths
- Thread starter Noroxus
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Tex Koder
2D , 3D Not a problem. I'll take that Challenge.
Lifetime Premium!
Premium Member
ArrmaForum Fan
Excellence Award
Hospitality Award
Build Thread Contributor
- Messages
- 10,042
- Reaction score
- 25,357
- Location
- Dallas, TX (USA)
- Arrma RC's
- Granite
- Infraction
- Kraton 6s
- Mojave
- Nero
- Senton 3s
- Typhon 6s
- Vendetta
Infraction / Vendetta - Short length
Granite / Senton - Medium length
Big Rock / Typhon - Long length
Kraton / Outcast 4S - Extra Long length
Granite / Senton - Medium length
Big Rock / Typhon - Long length
Kraton / Outcast 4S - Extra Long length
Hector_Fisher
Very Active Member
Might be a little off, but I did some measurements a long time ago when I switched my Senton to a big rock.
Senton front and rear a arms were about 87mm fron hinge pin to hinge pin. The RPM big rock arms I swapped to were about 100mm pin to pin (13mm more).
Upper senton links were about 70mm eye to eye on fronts and 66mm in rear. Thus I guesstimated the big rock needed to be 83mm front and 79mm rear. I remember it was slightly off when I finally installed it all, but that will get you in the ball park.
Senton front and rear a arms were about 87mm fron hinge pin to hinge pin. The RPM big rock arms I swapped to were about 100mm pin to pin (13mm more).
Upper senton links were about 70mm eye to eye on fronts and 66mm in rear. Thus I guesstimated the big rock needed to be 83mm front and 79mm rear. I remember it was slightly off when I finally installed it all, but that will get you in the ball park.
