Can you do me a quick favor and take a pic of the back of the spindle where the ball goes in, at full extension? I noticed the factory ones cut it super close to bottoming out on the ball stud, and I'm curious about the clearance on the aluminum ones.
Thanks! this is the pic I wanted to see. it gets close, but looks good enough. my fear is that if there wasn't clearance, it would bind there, possibly bending the ball end or gouging the knuckle on those hard cartwheels.
View attachment 4119
Thanks! this is the pic I wanted to see. it gets close, but looks good enough. my fear is that if there wasn't clearance, it would bind there, possibly bending the ball end or gouging the knuckle on those hard cartwheels.
View attachment 4119
Thanks! this is the pic I wanted to see. it gets close, but looks good enough. my fear is that if there wasn't clearance, it would bind there, possibly bending the ball end or gouging the knuckle on those hard cartwheels.
I finally found the time to run my Fazon and Nero to test out the Hot Racing parts! I gotta say I very impressed they ran like champs! No problems, did some moderate jumps to start, plenty of high speed turns and runs! I beat them pretty good! So I'll say Hot Racing is a must for your Nero,Fazon,and Big Rock!