Assembling Hobbywing Max6 - 4985 - what fits where?

[RC-Dude]

Tried to open the brushless motor in order to check the bearings. Screw would not come out even when heated. Tried a counterclockwise "get screw out drill" - not happening....

So I opened the other side, breaking away the epoxy protector. Now I am not sure if A is right next to bearing C. Or B right next to the bearing C.

I think it's A right next to C but I am pretty sure I have seen it the other way round in another motor.

Help appreciated.

 

[sandblaster]

B is a spacer. A is to keep the armature from walking back and forth. I would put B on the armature, then place C on the shaft and see if A fits against B. If it does, would put C on shaft and put in housing. That is my take.

 

[Tex Koder]

Here's a helpful video that shows the correct order of those bits that goes back into the brushless motor.

 

[RC-Dude]

Thanks for the video. Was very helpful! Especially with inserting the bushing the right way around. Would have missed that.