Mr.Vylan
If you're in control, you're not going fast enough
- Messages
- 998
- Reaction score
- 952
- Location
- Bay Area, California
- Arrma RC's
- Felony
- Kraton 6s
- Senton 6s
- Senton 3s
I'm looking to put a new body on my Senton 3s 4x4.
I'm looking at this body.
Pro-Line puts this in a category for (Arrma Senton 4x4) so I'm assuming it will bolt on with no mods.
https://www.prolineracing.com/bodies/chevy-silverado-1500-slash.asp
I just measured the stock body and it is 10 1/4 inches, concerned that the Pro-Line indicates 9.6" body width.
I've also looked at the following and since I'm new to the hobby I'm reaching out to verify this will fit. I'm aware I might have to do some modifications for the mounting holes but need to know if the overall width and length works.
https://www.jconcepts.net/shop/illuzion-slash-slash-4x4-and-sc10-manta-body)
I'm looking at this body.
Pro-Line puts this in a category for (Arrma Senton 4x4) so I'm assuming it will bolt on with no mods.
https://www.prolineracing.com/bodies/chevy-silverado-1500-slash.asp
Length: | 21" (533mm) | |
Width: | 9.6" (244mm) | |
Height: | 5.8" (147mm) | |
Wheelbase: | 12.6" (320mm) |
I just measured the stock body and it is 10 1/4 inches, concerned that the Pro-Line indicates 9.6" body width.
I've also looked at the following and since I'm new to the hobby I'm reaching out to verify this will fit. I'm aware I might have to do some modifications for the mounting holes but need to know if the overall width and length works.
https://www.jconcepts.net/shop/illuzion-slash-slash-4x4-and-sc10-manta-body)
Last edited: