Typhon Fitting a km2900x

[Mattyd926]

Ok so I know it is possible to fit a tp4070/km2900x by shaving down the rear a arm I was wondering if any of you that have done this and could I see some pics. I was going to move the motor mount but think I’m going to leave it be . Thanks in advance
In a typhon sorry

 

[GMballistic]

Personally if I was doing it and using the standard chassis still rather than a stretched one then I'd just move the motor mount.

Imho it's less of a bodge that way, will look better and keep more of the weight towards the centre rather than the back. All you'll need to do is drill some new holes and then swap the centre driveshafts around (front to the rear and vice a versa).

Otherwise if you do decide you still want to just shave the rear A-arm then I'd fit the motor to the mount, trial fit as best as possible and then using a sanding barrel on a Dremel or similar, slowly remove material from the rear A-arm where it fouls. Good luck.

 

[Mattyd926]

Thanks I made a jig and am waiting on s as chassis. F it I’ll give it a shot. I agree a lot of weight put back in stock location.