Outcast Hot racing motor mount

[robl45]

http://www.hot-racing.com/index.cgi?partnumber=AON38M01;c=926

anyone tried the motor mount. Seems very hard to find but if its better quality than stock, I'd take a chance with it.

Their diff on my mini summit has been fantastic. No more changing the diff after every two runs.

 

[Tsimonster]

They make great products. Since the Arrma stuff is backordered, I wouldn't hesitate to scoop one up. I've got a lot of their stuff and its all great quality. The adjustment from the top looks awesome.

 

[TwiZted SkullZ]

Just got one last week and have another one on order (Ebay)
They look pretty stout,and changing pinions should be a LOT faster.

 

[robl45]

Have you bolted it up? Any issues ?

 

[TwiZted SkullZ]

Have you bolted it up? Any issues ?

Working on it right now.....when done I'll start a separate thread with pics.
I'm also going to try to utilize the old mount to replace the original plastic diff mount.

 

[robl45]

Working on it right now.....when done I'll start a separate thread with pics.
I'm also going to try to utilize the old mount to replace the original plastic diff mount.

Yea, I was thinking of doing that too, luckily it stripped on the thread that gets cut off.

 

[TwiZted SkullZ]

Yea, I was thinking of doing that too, luckily it stripped on the thread that gets cut off.

That's weird cause that same screw broke off on mine.

 

[robl45]

What did you do to it? I did nothing but take it off a couple times to change the pinion

 

[TwiZted SkullZ]

What did you do to it? I did nothing but take it off a couple times to change the pinion

Bad crash doing almost 50 I guess!

 

[slpcrf450x]

That's weird cause that same screw broke off on mine.

I had a screw break off in mine as well. I took a tiny dremel tip and worked a slot into it until I could get it out with a screwdriver

 

[robl45]

Bad crash doing almost 50 I guess!

Oh mine didn't break, it just stripped. Went to screw it in and it never tightened up. Shouldn't break though.

 

[Tsimonster]

I rounded out the pinion set screw and then slipped when drilling it out and went through my finger, haha. I blame me being a little to heavy on the loctite thought, lol.