How to put driveshaft back together

[kaladeth]

Not exactly sure how this thing got pulled out, but is there a way to put it back in?

It’s the wheel side of the stock composite rear slider driveshaft on a Big Rock V3 3S (AR310864).

 

[gotnitro]

Yeah you’d have to pop the pins back into those ears but the ears look like hammered crap, best bet is to buy new.

 

[Rowdyray]

You're joking, right? I knew where your weak point was going to be. Did it last more than 10 minutes?

You can try metal ones. But, then you put the stress on the diffs.

 

[Deceased]

I had the same thing happen to me so on the side that doesn’t have the start (that thing that goes into the hoes) bend the side back and then place the side of the star onto the hole and align it to the other hole and use some channels locks and squeeze till the other side goes through it’s going to be tough at first but don’t give you just yet.

 

[kaladeth]

@Rowdyray haha you win the bet. It lasted five minutes. I don’t think I even got to full throttle yet… was just warming up.

 

[Rowdyray]

@Rowdyray haha you win the bet. It lasted five minutes. I don’t think I even got to full throttle yet… was just warming up.

Lol. What did I win? I'm rooting for you!

 

[Tex Koder]

Not exactly sure how this thing got pulled out, but is there a way to put it back in?

View attachment 361484

It’s the wheel side of the stock composite rear slider driveshaft on a Big Rock V3 3S (AR310864).

Too much kung fu-rce!