Limitless Limitless speed build: Murphy

[kaiserbasher]

what do you think about my long wires from XLX2 to TP, i measured 20cm AWG8, shall i move ESC to center brace and shorten the wires, is it worth?

 

[kaiserbasher]

except QS8, everything is in, hope you like it. It is not about like subscribe, i just want to show you my build

 

[Sky Corrigan]

what do you think about my long wires from XLX2 to TP, i measured 20cm AWG8, shall i move ESC to center brace and shorten the wires, is it worth?

I have to come up with a way to lengthen the TP wires as well. Any tips?

 

[kaiserbasher]

I have to come up with a way to lengthen the TP wires as well. Any tips?

my XLX2 came with some wires and bullets
https://www.castlecreations.com/en/cc-bullets-8-0mm
ans some AWG8 wire

 

[Sky Corrigan]

my XLX2 came with some wires and bullets
https://www.castlecreations.com/en/cc-bullets-8-0mm
ans some AWG8 wire

Nice. Depending where I'll place the ESC, the three wires will need to be longer. Good to hear it comes with some additional

 

[SrC]

In a perfect world shorter and heaviest guage wires rule. 8g. at least.

 

[kaiserbasher]

In a perfect world shorter and heaviest guage wires rule. 8g. at least.

i was thinkin, talking a lot about wires with different people, the outcome was pretty clear:
the wire between battery and ESC should be fat and short, large connectors, good soldering, because we are operating DC here (Ohm kills power)
between ESC and Motor we operate AC over 3 phases, means less alternating power over 3 wires => less effective electric energy

Conclusion: Long wires between ESC and Motor do have far less impact to kinetic out than long wires between battery and ESC.

But in general: short wire, short Ohm

 

[Sky Corrigan]

In a perfect world shorter and heaviest guage wires rule. 8g. at least.

Agreed. My plan is to mount the ESC as close as possible. Thanks man

 

[kaiserbasher]

Did some updates on my build:
futaba t7pxr with sbus telemetry
QS8 connectors
Understeering plates
Side panels
self developed "lauch control" module based on Atmel ATiny85 board
GT transformation (yes, i will remove the wing )

somehow, i am so sure that i will crash it during first run ...