Harry infraction
Member
- Messages
- 94
- Reaction score
- 51
Hello arrma friends
I have completely converted my Typhon to road and am currently driving 145 miles per hour on 6s and 75 miles in bashing mode. My problem is that the left rear drive shaft is falling apart because I am almost out of the way with the pins because it is so low. Definitely on the left a little more. I installed a Cvd from Gpm today as a test but it also pulverized after 3 rides and with only 3s but to be fair I have to say that it was a used one from my Infraction 8s. Yes I could set my fall to negative 5 degrees I'm sure the pins go in further, but I always drive in neutral when I fall because I don't use rubber tires. Are there slightly longer drive shafts that fit? I exclude CVD because it is not durable (the pin is too small and angled too much. I would be grateful for any help. I look forward to your answers. Thank you.
I have completely converted my Typhon to road and am currently driving 145 miles per hour on 6s and 75 miles in bashing mode. My problem is that the left rear drive shaft is falling apart because I am almost out of the way with the pins because it is so low. Definitely on the left a little more. I installed a Cvd from Gpm today as a test but it also pulverized after 3 rides and with only 3s but to be fair I have to say that it was a used one from my Infraction 8s. Yes I could set my fall to negative 5 degrees I'm sure the pins go in further, but I always drive in neutral when I fall because I don't use rubber tires. Are there slightly longer drive shafts that fit? I exclude CVD because it is not durable (the pin is too small and angled too much. I would be grateful for any help. I look forward to your answers. Thank you.