m.mahdi_sh
Member
- Messages
- 50
- Reaction score
- 17
- Arrma RC's
- Granite
hello everone
i've got one of these zee 5200mah 80C 3s lipos from amazon.
at first the battery connector was a t-plug and my imax b6 charging cable had the same connector. so i charged the battery, disconnected the battery connector, replaced it with the IC5 for my granite, and used it with my car and everything was fine.
so after the first pack i hadn't access to my b6 charger so i used my b3 imax that charges with the balance port only, so i charged the battery a couple of time with the b3 and used it with the car
in the last week i wasn't going to use the battery and didn't use the b6 to charge it at storage mode, so i put the battery on the b3 a lil bit to set it at storage voltage(just a feeling that it may became the storage voltage with the time calculation).today i finally changed my cable connector to be able to charge the battery with the b6
now it seems that only 1 cell is charging(number 1)
it reaches to 4.2 but not the other 2
so i changed to balance mode, but again the voltage of no2 and no3 cell didn't go up
what should i do?
i've got one of these zee 5200mah 80C 3s lipos from amazon.
at first the battery connector was a t-plug and my imax b6 charging cable had the same connector. so i charged the battery, disconnected the battery connector, replaced it with the IC5 for my granite, and used it with my car and everything was fine.
so after the first pack i hadn't access to my b6 charger so i used my b3 imax that charges with the balance port only, so i charged the battery a couple of time with the b3 and used it with the car
in the last week i wasn't going to use the battery and didn't use the b6 to charge it at storage mode, so i put the battery on the b3 a lil bit to set it at storage voltage(just a feeling that it may became the storage voltage with the time calculation).today i finally changed my cable connector to be able to charge the battery with the b6
now it seems that only 1 cell is charging(number 1)
it reaches to 4.2 but not the other 2
so i changed to balance mode, but again the voltage of no2 and no3 cell didn't go up
what should i do?