Velodromed
Snatching defeat from the jaws of victory!
Premium Member
Excellence Award
Build Thread Contributor
- Messages
- 7,758
- Reaction score
- 13,925
- Location
- San Antonio, TX
- Arrma RC's
- BigRock 4x4
- Granite
- Kraton 6s
- Kraton 4s
- Notorious
- Outcast 4s
- Vorteks
- Voltage
- Infraction 4x4
- Thread starter
- #41
I ordered a few GPM parts. I don’t plan on beating this car bad so they should work. Their cheap also and right now I don’t have the funds for m2c etc. They come in blue as well which works for me.
Starting off with the two lower front arm mounts. I want to install an RPM bumper that I have left over from the notorious but I don’t have the hinge pen retainer for it. These should suffice for that. I hope. Crap, now that I look at it I’ll probably still need a cap for the front retainer to keep the pins in place, dang it. Ugh, what part do I need for that??
Also got a Servo mount.
That’s it for today. Sure feels good getting started on it again.
Crap, just like stock the hinge pins are open at the front mount. Wish I’d seen this picture before I ordered it. What can I get or do to cover these? I want to use the rpm bumper I have, it’ll save me near $25 if I can
Starting off with the two lower front arm mounts. I want to install an RPM bumper that I have left over from the notorious but I don’t have the hinge pen retainer for it. These should suffice for that. I hope. Crap, now that I look at it I’ll probably still need a cap for the front retainer to keep the pins in place, dang it. Ugh, what part do I need for that??
Also got a Servo mount.
That’s it for today. Sure feels good getting started on it again.
Crap, just like stock the hinge pins are open at the front mount. Wish I’d seen this picture before I ordered it. What can I get or do to cover these? I want to use the rpm bumper I have, it’ll save me near $25 if I can
Attachments
Last edited: