Notoriousone
Very Active Member
- Messages
- 623
- Reaction score
- 1,472
- Arrma RC's
- Limitless
- Mojave
- Notorious
- Typhon 6s
Anyone else have this issue with Arrma vehicles, where the soft plastic wheels are jammed on so tight at the factory that the inside of the wheel literally gets grooves cut into it from the hub threads, and molds itself around the hub? This makes the wheels seriously hard to remove from the hubs, to the point of damaging the wheels. I had this issue on both my Notorious and my Typhon, I basically had to cut my V3 Typhon wheels with my Dremel just to get them off.. Not a big issue as I wasn't planning on using them anyway, but it makes me wonder if a human is putting these wheels on at the factory or a machine that is just doing it way too tight?
Another thing it seems like Arrma is fond of doing is putting crazy amounts of locktite on screws.. On some of the grub screws in my trucks I think Arrma completely dips the screw in locktite before installing.. crazy
Another thing it seems like Arrma is fond of doing is putting crazy amounts of locktite on screws.. On some of the grub screws in my trucks I think Arrma completely dips the screw in locktite before installing.. crazy