- Messages
- 141
- Reaction score
- 261
- Location
- San Diego, CA
- Arrma RC's
- Fireteam
- Mojave EXB
- Outcast 4s
- Talion EXB
- Typhon 6s
- Typhon TLR
- Vorteks
- Infraction 4x4
@LibertyMKiii or anyone else good with cutting foam tires? I'm looking for help cutting a 2.2 crawler foam insert. More specifically, I'm looking to use the insert with a short-course wheel, which is 3.0 inches v. 2.2. inches. I need to enlarge the center hole from 2.2 to 3.0 inches. I tried this with a sharp foam cutting razor but the whole ended up lopsided and looked like it was attacked by a shark. Any ideas?