CrayZee_One
Active Member
- Messages
- 50
- Reaction score
- 91
- Location
- Brisbane, Australia
- Arrma RC's
- BigRock 4x4
- Granite
- Kraton 6s
- Senton 6s
- Typhon 3s
Hi all,
knocked up a chopped Granite with buggy wheels, going for small and light.
All std Granite BLX 4x4 parts plus Typhon BLX 4x4 17mm axle setup and Louise buggy wheels.
Body mounts were fun. I used a moddified Typhon mount for the rear and for the front I reamed some holes in the front of the car and inserted the bumper setup attaching the bumber spring from the rear (but not to the chassis which makes a front hinged body.
Pretty happy with it on the test run. I'll change the rear shocks out as they are a bit too tight for this one as the rear hopped around a little too much.
First time chopping into a RTR body. I don't think it will be the toughest body after removing so much of it. Lots of gaff tape going inside body next!
knocked up a chopped Granite with buggy wheels, going for small and light.
All std Granite BLX 4x4 parts plus Typhon BLX 4x4 17mm axle setup and Louise buggy wheels.
Body mounts were fun. I used a moddified Typhon mount for the rear and for the front I reamed some holes in the front of the car and inserted the bumper setup attaching the bumber spring from the rear (but not to the chassis which makes a front hinged body.
Pretty happy with it on the test run. I'll change the rear shocks out as they are a bit too tight for this one as the rear hopped around a little too much.
First time chopping into a RTR body. I don't think it will be the toughest body after removing so much of it. Lots of gaff tape going inside body next!