- Messages
- 164
- Reaction score
- 270
- Arrma RC's
- Typhon 6s
As in vent my frustration. Haha, clickbaited here. No, no, it`s not about me being stressed out. I’m sitting here with the tires in front of me and I can’t cover the holes on the inside of the tire. Nothing seems to stick. I cleaned my Typhon 6S today. That went well. I tried to customized the body with my own stickers. That didn’t go well. The shell doesn’t like heat guns. It’s okay, I caught it quickly.
Let me walk you through what I have here for this Vent Tire project.
This power tape did not work at all. I tried electrical tape as well. Nothing sticks to cover the hole on the inside of the tire. Now, I don’t know what to get to cover that hole.
I got these diamond tipped tube drill bits. I have 4mm, 5mm, and 6mm. Not sure which is best. I was ready to go. If I can’t get this holes covered, I can’t vent right?
Last question. My tires are directional, correct? Is this the mark that tells me the direction to put the tires back on the rig?
In this picture below you can see I got the wheels all cleaned up.
I will check this thread again later in hopes that somebody has a good solution.
Let me walk you through what I have here for this Vent Tire project.
This power tape did not work at all. I tried electrical tape as well. Nothing sticks to cover the hole on the inside of the tire. Now, I don’t know what to get to cover that hole.
I got these diamond tipped tube drill bits. I have 4mm, 5mm, and 6mm. Not sure which is best. I was ready to go. If I can’t get this holes covered, I can’t vent right?
Last question. My tires are directional, correct? Is this the mark that tells me the direction to put the tires back on the rig?
In this picture below you can see I got the wheels all cleaned up.
I will check this thread again later in hopes that somebody has a good solution.