Harlon
Active Member
- Messages
- 398
- Reaction score
- 631
- Arrma RC's
- Kraton 6s
sup arrma gang ? so I got my m2c rear hinge pin kit in today and managed to install it. The install went great up until I went to reattach the bulkhead back to the chassis. Once I tighted the screws up, my whole entire rear suspension bound up really bad. Long story short, I had to do a bunch of dremeling to the rpm rear arms so they would swing free. I didnt over tighten the hinge pins so im not sure why the fit was so off. The only thing I can think of is these parts were designed to go onto the m2c chassis ? i did eventually get the suspension arms swinging free but it was more tweaking that what I used to doing with m2c parts. Anyone else have this issue? More specifically, the part of the arm that swings on the hinge pin was binding up with the top of the chassis. So i had to take some plastic off the bottom of the arm to free it up. Maybe I've just been lucky with all my aftermarket parts fitting perfectly and $hit like this us somewhat normal ??