crunchtime
Active Member
- Messages
- 287
- Reaction score
- 555
- Arrma RC's
- Granite
- Outcast 6s
- Vorteks
See any reasons why these two methods (described below) can't work?
Quickly realizing a downside to moving multiple rigs onto a DX5. Sometimes my kid and I or his friends bash / race at the same time, and take turns on who runs what.
Since one receiver can't be bound to two transmitters, and it takes some of the fun out of it to have to take the time to remove the lid off the receiver box each time you want to bind....
On the outcast 6s, maybe try a pin hole in the lid of the receiver box to access the spektrum logo push-button thing. Could probably put a little piece of electrical tape over the hole to keep the moisture out.
On the Vorteks, the receiver is harder to reach. So maybe connect a bind plug and just permanently run two wires to outside of the box, where I can make or break the connection. For the outcast 6s, it could also use a bind plug instead of the push button, right? If so, then maybe don't do the pinhole on the outcast and instead do the two wire thing.
Won't be able to see the LED during binding, but I could live with that.
Thoughts ?
Quickly realizing a downside to moving multiple rigs onto a DX5. Sometimes my kid and I or his friends bash / race at the same time, and take turns on who runs what.
Since one receiver can't be bound to two transmitters, and it takes some of the fun out of it to have to take the time to remove the lid off the receiver box each time you want to bind....
On the outcast 6s, maybe try a pin hole in the lid of the receiver box to access the spektrum logo push-button thing. Could probably put a little piece of electrical tape over the hole to keep the moisture out.
On the Vorteks, the receiver is harder to reach. So maybe connect a bind plug and just permanently run two wires to outside of the box, where I can make or break the connection. For the outcast 6s, it could also use a bind plug instead of the push button, right? If so, then maybe don't do the pinhole on the outcast and instead do the two wire thing.
Won't be able to see the LED during binding, but I could live with that.
Thoughts ?