ph47mf
Active Member
So last few days I sold my K4S and bought a blue K6S. It was £100 more than usual but the itch had to be scratched. This thing is a lot more complicated than the 4S.
I also ordered some RPM arms and bumper, i thought one pack contains 2 arms for the front which is enough, it turns out there are 4 arms at the front. ?
I took a bit of time to dismantle things and ran into a few issues. I wonder if you guys can help.
1) I couldn't get any of the red wheel hub off, after a lot of force I got the grub screws out, took the pin out, but still can't pull it out, am I doing something wrong?
2) I pulled out the dog bone to install the rear RPM arms and 3 little spacers dropped out, after I put the arm on, I could only fit 2 spacers back in, is that ok? The dog bones are quite tight up against the cup as well and there's a big gap between the rear hub and arm along the pin pictured below, is that normal?
3) I took out the front wheel and found some damage behind it and on the steering hub (not sure what to call it), ask for a new one or just leave it?
4) do I need spacers between front arm and the metal bit at the end? The cheap plastic ones keep falling out.
5) have I installed the RPM front bumper correctly? It looks a bit odd with the stock bumper behind it.
Thank you guys
I also ordered some RPM arms and bumper, i thought one pack contains 2 arms for the front which is enough, it turns out there are 4 arms at the front. ?
I took a bit of time to dismantle things and ran into a few issues. I wonder if you guys can help.
1) I couldn't get any of the red wheel hub off, after a lot of force I got the grub screws out, took the pin out, but still can't pull it out, am I doing something wrong?
2) I pulled out the dog bone to install the rear RPM arms and 3 little spacers dropped out, after I put the arm on, I could only fit 2 spacers back in, is that ok? The dog bones are quite tight up against the cup as well and there's a big gap between the rear hub and arm along the pin pictured below, is that normal?
3) I took out the front wheel and found some damage behind it and on the steering hub (not sure what to call it), ask for a new one or just leave it?
4) do I need spacers between front arm and the metal bit at the end? The cheap plastic ones keep falling out.
5) have I installed the RPM front bumper correctly? It looks a bit odd with the stock bumper behind it.
Thank you guys