Outcast Should have looked @ the parts diagram…..

[lipo-joe]

bought the 35x35 instead of the 30x30 fan
amain said there is no issue w/ a return - it held up, but I don’t trust just having 2 screws in the heat sink

 

[Moonstonemike]

Know anyone with a 3d printer? They have adapters you can print out.

 

[King blitz]

bought the 35x35 instead of the 30x30 fan
amain said there is no issue w/ a return - it held up, but I don’t trust just having 2 screws in the heat sink

View attachment 311687

I have a similar set up in one of my buggy's and the fan screws going In to the heat sink works well .no issues

 

[lipo-joe]

Know anyone with a 3d printer? They have adapters you can print out.

sadly I don’t have access to a 3d printer
this protek fan is pretty dang good - 100x better than the stock fan

 

[Senton_Prime]

@Tex Koder has some, I'm sure he has all the required sizes.. I need to purchase a few from him!!
Also, pull the HS off and toss it in your parts bin, get a proper fan mount!!

 

[RCbuzz]

I know a guy that trusts his oversized fan to one screw

 

[sumguy75]

I have 35mm & 40mm fan on my 4092 motor and it has held fine so far, 2 screws in one, 1 screw in the other.