Limitless Which signal booster is best?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

dure16

Premium Member!
Premium Member
Build Thread Contributor
Messages
6,187
Reaction score
9,059
Location
Illinois
Arrma RC's
  1. Fireteam
  2. Infraction
  3. Limitless
  4. Kraton EXB
  5. Talion
  6. Typhon 6s
  7. Typhon TLR
My Radiolink loses signal as the car nears the speed run start or finish point. Those are some long walks.

Has anyone here installed a booster and seen noticeable improvement? Which booster do you use?

Thanks
 
My Radiolink loses signal as the car nears the speed run start or finish point. Those are some long walks.

Has anyone here installed a booster and seen noticeable improvement? Which booster do you use?

Thanks
I have a Turbowing booster on my Radiolink

My first Radiolink V2 had some range issues no matter what I tried to do

This one is a new V3 of boks

You need to unsoldered the stock antenne so the booster can be soldering on , not the easiest because it's really small

Had not been testing it yet, bad weather here in Denmark mostly and I been moving to a new home

I hope it will booster more than enough
DSC_5486.JPG

DSC_5487.JPG


I got the power wire inside, lot of room
Just not in here yet
DSC_5485.JPG

I did a xt60 for power, so I can run on a 3s and 4s battery

Can take a picture of it later
 
I have a Turbowing booster on my Radiolink

My first Radiolink V2 had some range issues no matter what I tried to do

This one is a new V3 of boks

You need to unsoldered the stock antenne so the booster can be soldering on , not the easiest because it's really small

Had not been testing it yet, bad weather here in Denmark mostly and I been moving to a new home

I hope it will booster more than enough
View attachment 362510
View attachment 362512

I got the power wire inside, lot of room
Just not in here yet
View attachment 362511
I did a xt60 for power, so I can run on a 3s and 4s battery

Can take a picture of it later
That’s a clean install! You’ll have to share the results once you get a chance to test.

A quick question: why does it need a separate power source? I use a 3S LiFe battery for my transmitter. Is there any reason I couldn’t use the same battery to power both the transmitter and the booster?
 
Back
Top