- Thread starter
- #21
Check to make sure your esc fan is plugged in correctly and not causing the esc to go into program mode.
What brand, mah, C rating, age etc are your batteries?
That can make a huge difference how the truck runs.
I am running two SMC 4300mah 3s 40c batteries if my calculations are right that is 172amps likely burst, I guess that is constant, burst is 80c, I may try unplugging the fan to see if that changes anything the fan is perfectly functional... The failure I is intermittent I ran it once when I got the esc back in the snow with sling shot paddles on it, no issues ran it till the red LED went off (cutoff light) then again I ran it with fully charged packs like I did last time, and I got a green blinking light at 3.9volts per cell as per the checker...
The cutoff is at 3.4 volts per cell I checked the packs were done, I don't usually run them that low... I am really considering getting a used mamba monster combo.... So, I guess likely monday I will call them again, and ask about my 20 ton press tactic, I think its genius and would be a stress reliever, take a video of me squashing it flat as a pancake and get a new unit