- Messages
- 4,248
- Reaction score
- 7,413
- Location
- SE PA
- Arrma RC's
- Kraton 8S
- Kraton 6s
- Mojave EXB
- Outcast 6s
- Talion
- Typhon 6s
I am running two set screws 180 deg apart (lots of Loctite). The gear has two tapped holes. If that fails I would buy another shaft and drill thru it so I can run a screw thru it and the gear to drive it. not sure what the other guys are doing. I think theres some mods on fb but I'm not on there. I might eventually bite the bullet and go with another motor. Right now I have a Rocket 790(or 780?)kv 56112.I have been wondering what people do to get a different spur fitted to the k8s.. I noticed the stock one has a keyed opening to it and the limitless spur for example is just round. What exactly was needed to make a different spur fit?