- Messages
- 223
- Reaction score
- 476
- Arrma RC's
- Kraton 6s
- Outcast 6s
So I've wanted a TP Power motor for a while now and i was wondering if it's possible to fit a TP5660 into a short wheelbase chassis like the same length and motor placement as an Outcast 6s?
I know a few of you guys are experienced with TP motors and thought someone might have tried this or have some input for me.
I think i read somewhere that someone said the largest can length you can fit in the outcast without some alteration is 87mm, the 5660 comes in at 92mm i believe. Could you get away with the extra 5mm with a little modification, is so what would be required to make it fit?
Or is the information i'm spouting out above just plain wrong?
Thanks for any help.
I know a few of you guys are experienced with TP motors and thought someone might have tried this or have some input for me.
I think i read somewhere that someone said the largest can length you can fit in the outcast without some alteration is 87mm, the 5660 comes in at 92mm i believe. Could you get away with the extra 5mm with a little modification, is so what would be required to make it fit?
Or is the information i'm spouting out above just plain wrong?
Thanks for any help.