Adamd
Fairly New Member
- Messages
- 35
- Reaction score
- 8
- Thread starter
- #21
Ok cool thanks and I did try loosening the slipper and it seems extremely sensitive if I barely back it off from fully tight it slips a lot and barely moves how do you set yours?For some reason I was only breaking fronts, then I adjusted my slipper and I've had the same set on it for about a year, they are getting a bit wore out though.
And @Adamd Arrma does make an upgrade for those as long as you have the Senton, Granite or Big Rock https://www.arrma-rc.com/part/AR310870 they will work on the Typhon but you will have to use one of the 17mm hub adapters for the Granite, Senton or Big Rock.
I don't jumpRelease your throttle when you land from a jump, made a huge difference
I'll take em off your hands lolTyphon 3s from 2019 and now running 6s motor and electronics. Original driveshafts. Granite 3s February 2020. Original driveshafts. What sucks is I bought about 5 extra sets from Jennys Rc back in 2019 expecting exploding shafts, but now they just take up space in my 3s parts box
I drive it on grass and gravel I try to go as fast as I can I'm running 4s and other than that it's just the occasional rollover . I'm not doing anything specialPlease explain. Pics help. I have ran 3s driveshaft on 6s so there clearly must be some sort of user error.
Since I just put on an old drove shaft for now these are two examples of the problems I'm running into with the drive shafts. I've never had the hex come loose and I've never thread locked them either precisely because of these two problems
Believe me that cussing was very much filtered because I know I need to watch what I say however I just posted a picture of 2 examples of my driveshaft issuesPost some pics like mentioned , I'm sure some good suggestions will pop up and find the problem quicker that cussing...
However we definitely understand the frustration.
Attachments
Last edited: