Velodromed
Snatching defeat from the jaws of victory!
Premium Member
Excellence Award
Build Thread Contributor
- Messages
- 7,758
- Reaction score
- 13,929
- Location
- San Antonio, TX
- Arrma RC's
- BigRock 4x4
- Granite
- Kraton 6s
- Kraton 4s
- Notorious
- Outcast 4s
- Vorteks
- Voltage
- Infraction 4x4
So…is steering part of suspension?
Okay I’ve been working on putting bearings in the Ackerman bar. Finally got it and works very well. I’m doing this for an m2c bar which is thicker then stock. Used the stock shoulder screws to secure.
4x7x2.5 flanged bearings
4x7x.08 washers
I used the below. Not the best bearings but this was an experiment and they are better then the stock bushings at least. The bearing pops in from below and set a single washer on top. Smooth and no play.
Yup I’m happy
Okay I’ve been working on putting bearings in the Ackerman bar. Finally got it and works very well. I’m doing this for an m2c bar which is thicker then stock. Used the stock shoulder screws to secure.
4x7x2.5 flanged bearings
4x7x.08 washers
I used the below. Not the best bearings but this was an experiment and they are better then the stock bushings at least. The bearing pops in from below and set a single washer on top. Smooth and no play.
Yup I’m happy
Last edited: