Hey guys. So I’m in a bit of a snag here. I had taken my car out last week for it’s first a run with the new motor/esc and other goodies.. first pass I made was quite decent and on my second pass I destroyed my rear drive shaft.
So I ordered new shafts and spool and after putting it all back together now my mamba X is not making any sounds at start up and not recognizing the throttle.
One thing I noticed when putting it back together Im was that one of the esc cables was disconnected. I wasn’t sure if it had popped out due to the drive shaft impact or what. So I put it back. And now this.
I don’t want to imagine that after 1.5 runs that my esc is out.
So I ordered new shafts and spool and after putting it all back together now my mamba X is not making any sounds at start up and not recognizing the throttle.
One thing I noticed when putting it back together Im was that one of the esc cables was disconnected. I wasn’t sure if it had popped out due to the drive shaft impact or what. So I put it back. And now this.
I don’t want to imagine that after 1.5 runs that my esc is out.