- Thread starter
- #21
Thank you for the info!
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Do you have the V2 or V3?Three must do mods to the Senton are:
1. Cover to stop crap getting in. Dusty Motors cover for the Senton is actually for the 6s version but works OK on the 3s. Disposable catering hair net much cheaper and works well.
2. Take the motor pinion off and put a couple of o rings under it to stop dust getting in the motor bearing. Possibly not so important on the new V3 motors but do it anyway.
3. Get some double sided foam tape (3M if you can), peel off one side only and stick it to the bottom of the spur gear housing. Cut a small rectangle where the spur gear pokes out a bit. This stops grit getting into the spur gear.
If you do the hair net option you can do all threee of these for less than ten bucks/quid/euro...
Optional mods:
Shim the spur gear if it rubs on the housing. (Look for black dust inside)
Replace the radio. I have the Flysky GT5. Much better response and the giro makes a huge difference to keeping it going straight no matter the speed or surface.
View attachment 104985
V2. If you were getting a V2 you'd also want shielded bearings and a motor cooling fan but I assumed you were going for a V3.Do you have the V2 or V3?
Just bought the V3. Haven't even taken out of the box yet!V2. If you were getting a V2 you'd also want shielded bearings and a motor cooling fan but I assumed you were going for a V3.
Register and gain access to Discussions, Reviews, Tech Tips, How to Articles, and much more - on the largest Arrma RC community for RC enthusiasts that covers all aspects of the Arrma-RC brand!
Register Today It's free! This box will disappear once registered!