JMS RC
Active Member
- Messages
- 231
- Reaction score
- 642
- Location
- Sweden
- Arrma RC's
- Infraction
- Kraton 8S
- Kraton 6s
- Kraton EXB
- Nero
- Outcast 6s
- Talion
- Typhon 6s
- Typhon 3s
I would like to get the front suspension sit so that the axles are horizontal. Even if I mount the shocks in the inner hole on the a-arm and in the lower hole on the tower and turn the collars all the way down on the shocks, it is still too low. Been reading about folks swapping out the springs for Tekno RC but the V3 is supposed to have springs that are very equal to those Tekno RC orange ones. I run the stock 2000cst shock fluid since it's summer and warm outside. These pictures are taken just after a run, pic 1 after the front been pushed down and pic 2 if i pump it up and down a dozen times. Nothing in the suspension is binding. Is it supposed to be like this or am i missing something ?? Change to a lower viscosity fluid ?
Rear is just fine, a little above horizontal although I had to turn down the collars quite a bit.
Rear is just fine, a little above horizontal although I had to turn down the collars quite a bit.