- Messages
- 3,162
- Reaction score
- 3,642
- Arrma RC's
-
- Fireteam
- Granite
- Infraction
- Kraton EXB
- Typhon 3s
- Typhon TLR
The seller is saying a Castle employee wired up the cap pack this way for him. I find it hard to believe they’d completely cut the battery wires off and rely on a solder joint to carry the entire battery current.
Isn’t normal practice to leave the wire intact, slice a bit of rubber off, and use that opening to solder the cap pack?
Would you trust this setup?
Isn’t normal practice to leave the wire intact, slice a bit of rubber off, and use that opening to solder the cap pack?
Would you trust this setup?