LudeNation
Active Member
- Messages
- 138
- Reaction score
- 204
- Location
- Texas
- Arrma RC's
- BigRock 4x4
- Granite
- Infraction
- Notorious
- Senton 3s
¹)What slicer are you using?I have Tons of them..
From trying out different slicer settings (wanting to print "faster.." ; to a variety of orientations of the part(S) attempting to achieve a "better" surface finish.. ; to just changing filament color... Prints can & will fail unexpectedly..
So, I'll go first..
Started this print last night.. thinking it's completed over 25% already , everything looked good, should be fine.. Went to bed ,I was tired....
Woke up to this wonderfulness! >>
View attachment 288248
View attachment 288249
View attachment 288250
View attachment 288251
View attachment 288252
It was printing vertically , going up on its side beautifully..
First layer was perfect.
Tree supports had brims too ,for extra stability.
²)Find profiles from the community like CHEP on YT.