- Messages
- 2,294
- Reaction score
- 2,885
- Location
- Maryland
- Arrma RC's
- BigRock 4x4
- Felony
- Granite
- Infraction
- Kraton 8S
- Kraton 6s
- Kraton EXB
- Outcast 6s
- Typhon 6s
- Thread starter
- #21
Belts are snug, wheels tight too, and bed is level. I’ve upgraded the extruder and bed springs. Unfortunately I don’t have another botched print. I guess my next step would be to invest in a dryer and enclosure. Do you have a link for the enclosure?The shifting you are seeing isn’t from wet filament or settings in the slicer. The machine it self is off. How tight it the drive belt on the gantry? Do you have a pic of the other parts that had shifts in them? If you are wanting to work with ABS you must have a setup like this for best results. The dryer is directly fed into the machine while also in the enclosure with desiccant packs in it for additional protection as well as in the dryer. Call me Paranoid with those extra steps go very far when it comes to the finish of the product
View attachment 181443
Authentic Creality Aluminum... https://www.amazon.com/dp/B07ZMFP2L8?ref=ppx_pop_mob_ap_share